Recent content by Chistopher

That's what the plan was most likely going to be, but seeing as I have a general engineering degree and a decent amount of handiwork skills, it would be neat to at least try and figure out and if it's something simple fix it myself. Also I know there's such thing as fluids that fix leaks, but...

I know very little about the radiator system in cars, but it would appear my car is leaking coolant. I noticed my heater wasn't heating my car so I checked the reservoir and the fluid level was at the bottom. I topped the car off, but the the engine wasn't 100% cool, however it had probably been...

Any advice to get the moisture barrier off to get the broken glass out? I'm struggling a bit with it.

I actually got a little lucky. I drove past a scrap yard and decided to see if they had anything, they had a window in good condition that matched my tint (except I think it's film instead of ceramic) for $80.

I may have to do that. It just occurred to me that one of my friends manages a Ford dealership

I was in DC over the weekend (parked on a well lit highly visible road) and some goober broke into my driver side window to steal an old backpack full of clothes I was going to donate. I'm normally wary of buying off Amazon, but they are the only windows I see for sale online. Are they a good...

Howdy folks. I finally installed the new subs in my doors. The only issue being that I had to cut the enclosure to make them fit. What must I do to reseal the enclosure. Also, will issues will I run into if I don't? I have a high and low pass filter going into to the sub if that makes a difference

I have found one. One question though, is the power rem wire on the new amp the same as the mute wire on the old one?

Stock amp wiring diagram

Kicker Key 500.1 diagram

How do the stock door subs amp work? There are 4 output wires per amp that are the hot and ground for each subs coil, but how do the 6 output wires work? If I had to guess 4 of then correspond to the 4 inputs and the other 2 are the power and ground to the amp. But then this leaves the question...

Also, whats the ideal location for the fuse box?

Cool, thanks. 8 Guage is still good for post-distribution block? What's the general rule of thumb for wire sizing?

Howdy fellas, I have a kicker 200.4 that requires a 20A fuse amd a 500.1 that requires a 60A fuse. My plan is to run a 4 guage wire to a fuse, then run that to a distributor that splits into two 8 guage wires. What fuse size would I need? Also, an alternative is run the distributor first, then...

Howdy fellas, I just did a swap from a 4 to 6 guage cluster on my 07 v6, and was wondering if it would possible to drill through the outer "buttons" on the placeholder button cluster, screw into the holes, and yank it out. In short, is there anything holding the buttons in place other than...