I will... these came out of a GT I parted a couple years ago and were put away as I already had a set of new ford mats. As I remember they were in good condition or i would have thrown them out.
MADGT I believe I have the fronts with the GT script tucked away in the garage... I'll try and get out there and try and dig them out and take pictures of them for you...
DR3V-7A543-AA is an engineering number....it is not a part number. I have sent an email to them to confirm that what they have on hand is actually metal as it would be on the DR3Z-7A543-A. Their descriptions are not always correct and I have seen it multiple time.
The 2011-2014 GT (Non Brembo) brake upgrade....
Uses your caliper, the 2011-2014 GT front caliper brackets and the front rotors from the 2011-2014.
That will give you a upgrade from the 12.4 inch rotors on the 2005-2010 GT cars to a 13.2 inch front rotor for better braking..... the calipers...
The JPC crossmember was perfect... everything lined right up... Watson Racing also makes a crossmember for the TH400 swap too, but have only used the JPC setup... being that it lined up as it did, we could probably use their driveshaft too as we converted the 8.8 to a 1350 style yoke when we...
Yes there is... going back to the A/C lines... you could probably buy a few feet of the hose from the same place you got your fittings and mock up everything then have your hoses crimped at any place that does the hydraulic lines for big trucks or tractors.
We were fortunate on my best friends...