Recent content by MisterFurious

No washers or clips

Yes, new everything, and had the calipers rebuilt.

Unfortunately I don't have the original rims and tires, but the shimmy started when those were installed, and it did not go away or change at all when the rims were changed (or multiple sets of tires). Again, issue was unchanged after new power stop extreme brake kit was installed. Since it...

Watched a few videos of people with EPAS issues... doesn't seem to be the same symptoms as mine has, mine is definitely rotational, not just a continuous shake-- and not effected by traction control either. Just to rule that out

It seriously feels like an slightly out of balance washer on spin is mounted to my hood

Calipers were just rebuilt when the brakes were done, about 500 miles ago. I've checked both fronts and they spin freely, and the backs as well. ZERO play in front wheels also, ball joints were new as part of the new front control arms, and new tie rods, also about 500 miles ago. None of these...

I checked diff bushings, lower control arm bushings, all across everything looks very good. This car hasn't been beat on, or run with slicks/drag raced, so it's pretty fresh under there.

I put it on jack stands this morning. I put sharpie marks on the bottom of the car in line with the tire treads and slow rolled it, no noticeable wiggle or oval. Pretty much right down the center all the way around. I looked at the side profile and no wiggle either.

Dash definitely shakes, mirror shakes, windshield phone mount, steering wheel

No washers

I've checked with two sets of lug nuts, both seat well, and the shaking wasn't affected, so I don't think that's an issue.

Thank you for everyone's responses so far--you give me hope!

I'll get underneath it tomorrow AM and check those bushings

I haven't had anyone pull the axles out to inspect, but "jostle" is a good descriptor--feels like I have a clothes dryer full of wet towels mounted to the front of my car.

is there any way to tell without removing the tire?