Search results for query: *

  1. Aussie-Parnelli

    Broken Brake Booster Vacuum Hose (2007 Mustang Gt)

    It is replaced by a generic part The one on the top is off my '06 Saleen the one on bottom is generic Try Autozone or Pep boys they will be able to help you Also both manual and autos use same part they are designed to keep vacuum in booster and has nothing to do with transmission
  2. Aussie-Parnelli

    BMR K member & A arm install

    Yes BMR lower arms do fail, this was mine last year, when I contacted BMR they said they had never seen this before. Would not offer any form of warranty. I ordered 2 new ones which in fact when they arrived each weighed over 2lb heavier than older styles which tells me BMR did have a problem
  3. Aussie-Parnelli

    Throttle control clicking/vibrating when key turned on

    Sorry it is throttle control side of throttle body not throttle position sensor
  4. Aussie-Parnelli

    Throttle control clicking/vibrating when key turned on

    Went to start car today after sitting for sometime, Initially started run for approx 2 minutes and then cut out. When i tried to restart I heard a clicking sound coming from the throttle control and car won't start. Noise stops when I disconnect the pig tail from controller, reconnect no...
  5. Aussie-Parnelli

    BMR suspension failures

    Hi Has any one had issues with BMR front lower arms on S197 Mustangs
  6. Aussie-Parnelli

    Misfire

    https://www.ebay.com/itm/154801920880
  7. Aussie-Parnelli

    Misfire

    Hi I bought one of these for my '06 race car, Turned out to be 2 bad COP pigtails They are cheap and work High Quality Checker Coil On Plug COP Ignition System Quick Tester ADD 750
  8. Aussie-Parnelli

    08 4.6 Misfires

    Hi I just found the cause to my misfires on my highly modified '06 I replaced the plugs and coils only for the miss to return It ended up being the COP wire connectors Seems to be fine now and was an easy fix
  9. Aussie-Parnelli

    Classic Car Pictures.

    [Thunderbird 60s? Is this like yours Aussie-Parnelli? Hi Daniel No that is a '63 Thunderbird mine is a '65 I bought my wife a '62 M series T-Bird from Sacramento in '93 shipped it to Australia and restored it. My wife and I do all the work including painting ourselves. But I do get the panel...
  10. Aussie-Parnelli

    Classic Car Pictures.

    Bought the T-Bird at Pomona in 1991 as a going re-builder Shipped it to Australia and completely dismantled it and rebuilt in 12 months Fitted a 1970 Mercury Cyclone 429 SCJ Drag Pack engine with 4 Speed Top Loader and Detroit Locker Differential Just love this car as it is so different to all...
  11. Aussie-Parnelli

    Gauges coming on when headlights turned on

    Had a problem last night at racing Car run fine until evening when I turned headlights on. Car started misfiring and when I returned to pits the car continued to run when I turned key off Turning the headlight off engine stopped. Now when I turn lights on the instruments and warning lights...
  12. Aussie-Parnelli

    KB - T56 Upgrades (Conundrum)

    I run a T56 in my '06 converted to a Pfitzner PPG Dog Box about 6 years ago it has a 1st gear 2.437 6th gear .77 also run 4.1 rear gears Current horsepower at engine 746hp but recently done some more mods and having dyno done on Wednesday Just love the extremely fast shifting of the PPG gears on...
  13. Aussie-Parnelli

    2010 4.6 timing/misfiring issues

    I just found the cause of misfire on #2 cylinder it was the pigtail connection to coil as it no longer locked in place, make sure all your connections are firm
  14. Aussie-Parnelli

    Ignition Coils

    In regards to my coil issues I finally found the real problem it was the pigtail connecting the number 2 cylinder the locking device no longer worked and allowed the intermittent misfire I was experiencing, I also put the original coils back in. Having a new fuel system built with 2 20A Bosch...
  15. Aussie-Parnelli

    Ignition Coils

    Interesting I bought the vehicle in Feb '07 the car was 3 months old in Sacramento shipped it to Australia and had converted to Right Hand Drive, and then the journey started. Many, many modifications over the pursuing 15 years and changed lots of parts. Today it has around 22,000 miles but most...
  16. Aussie-Parnelli

    Ignition Coils

    What ignition coils are recommended for the 3 Valve I am currently running the original coils but after changing several sets of plugs including NGK I am getting breakdown at load Have fitted latest HTO plugs The 302 Extreme engine with many mods was pulling 746 flywheel horse power with 12lb...
  17. Aussie-Parnelli

    Melling M340HV oil pump thoughts?

    When you replace your oil pump make sure you change the plastic tensioners, I read about this problem some time ago and ordered a set of steel ones and I also updated the pivot bolt with an 8mm thread unit. The tensioner seal was blown out on the LHS S I do race my '06 it is stroked and runs...
  18. Aussie-Parnelli

    Motorcraft Wire Pigtail Guide

    What is part number for the male connector that fits the 2013 Sun visor fitting them to my '07 Parnelli
  19. Aussie-Parnelli

    S197 Values - current asking prices vs mileage

    I live in Australia and own 4 Saleen S197's I got the same message from my mother, it took a while to sink in but it was a true statement. Paid my mortgage of in 8 years that was 1985 and have paid very little interest since....almost nothing. It really allows me to enjoy my cars which we own...
  20. Aussie-Parnelli

    Mouse invasion

    We used to have that problem here in Australia, mice love rubber and silicon I was advised to put moth balls in engine bay and trunk. Rodents don't like the odour Have not had an issue since fitting them, remember to check them every few months I use these and just hang one on a cable or wire
  21. Aussie-Parnelli

    probed the fuse box... oops...SOS

    Hi I just had a similar problem, fitting heat exchanger fans. Has taken a couple of months to rectify. Car would start but run in limp mode, I got throttle body codes after replacing throttle body and sensors didn't change. Removed my wiring, and swapped out fuses and relays still the same. Then...
  22. Aussie-Parnelli

    Throttle Body Chatter

    Ok Thanks for your help guys Done the relearn......didn't know about this Still got same issues The throttle body I tried was a brand new Ford replacement with the TA and TPS I Changed the Throttle Pedal with one of my other cars....no change The readings I am gettle from TPS with the Throttle...
  23. Aussie-Parnelli

    Throttle Body Chatter

    Hi I have a heavily modified Saleen S197 which I took to the dyno several weeks ago. The car was running fine when I dropped it off. Got a call to say there was an issue and was in limp mode Unfortunately here in Australia there are not many S197's Took the car home and it will only start with...
  24. Aussie-Parnelli

    Water in oil

    No definitely water, hadn't added coolant in case there was a problem. Fired engine up for approx 3-4 minutes shut it down went through normal checks and found this horrible grey water/oil mix on dipstick probably a half litre/pint extra in sump. Have pulled sump off to clean it out and can't...
  25. Aussie-Parnelli

    Water in oil

    Have just changed cams on my '06 started no problems run good for about 4 minutes only to find water in oil. only removed valve covers and timing cover to do swap. Any ideas where to start.

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top