Recent content by bambam 06

  1. B

    Technical headlight question

    https://www.americanmuscle.com/05-headlights.html.
  2. B

    Technical headlight question

    The only way you can change your headlights/tail lights with out spending $$$$$ is buying them at American Muscle.
  3. B

    Loud radiator fan? As soon as start

    See #16 below.
  4. B

    Loud radiator fan? As soon as start

    Exactly where i ran it to, Thank you.
  5. B

    Loud radiator fan? As soon as start

    I just received the new fan resistor from wireeverything, it has no info on where to attach the ground wire that comes with it. is about 30 inches long, can it be attached to any ground point or is there a specific ground point that it must be attached to? Thank you for your help.
  6. B

    Loud radiator fan? As soon as start

    Did you install it, how difficult was the installation with the fan in the car. Thank you.
  7. B

    Guide for Replacing Fuel Injectors

    my usual shop wants $500 to do them. Time to find another shop!
  8. B

    Double Gasketed Oil Filter, Now Getting P0345/P0349 Codes

    Do not lower the car till oil is in the engine and run it to check for leaks, it will avoid all of the above.
  9. B

    Double Gasketed Oil Filter, Now Getting P0345/P0349 Codes

    Leaf blower will do, that is what i use.
  10. B

    Won't start..

    It was diode P/N YL8Z-10Z912-AA that was bad. There are two in the engine buss, one for the A/C compressor and the other one for the switch chip that recognizes the key.
  11. B

    Won't start..

    2006 mustang gt will not start with any of the two keys,i am getting code B1600. What do i do-help!!
  12. B

    Double Gasketed Oil Filter, Now Getting P0345/P0349 Codes

    Formula 88 and a pressure cleaner, make sure you wrap the coils, air filter and fuse box with plastic. It will look like new again.
  13. B

    Double Gasketed Oil Filter, Now Getting P0345/P0349 Codes

    Did you clean the engine, oil still all over.
  14. B

    Pedals too close together

    You would have to remove the pedal's take them to a shop, where they will heat the pedal and bend them an inch or two.

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top