Recent content by dsblk93gt

12.82@111 bone stock in my 2013 3.31 gears with the stock 235/50 all season garbage

Were the before #'s with the Roush supplied tune?

Nice man, can't wait to see the progress pics!

Awesome work!!

Impressive!!!!

So what pulley with the D1SC makes 7.5 lbs?

I am impressed with the Roush kit, VMP's car is running mid 10's @133 with it.

Nice!! Was it spinning? 60fts could be alot better but wasn't sure if it was bogging or spinning..

If I had a S197 and had to choose between the two I'd get the Roush. 450rwhp "should" be enough to run high 11's easy and would be fun on the street. I have drove a few Terminators and raced them at the track, and drive my friends modded -07 GT500 so I like the positive displacement SC's alot. I...

Stick it on ebay thats your best bet.

There is nothing but bore spacing thats the same like said above. This engine is totally different.

Now to see how much the dealers will mark these up.

Yes, M90's scream since they are being turned pretty high rpms.

Like removing duct tape residue but worse..haha.

I always had good luck with ControlTac vinyl but never used the Di-Noc before. I worked at a sign shop for over 6 yrs, but nobody wanted to spend the $$ for that stuff. It's also not something you can remove easy after it is on for a while. It is a permanent architectural vinyl, and when you use...