Recent content by Earthworm

Thank you for taking time to respond. I will look at that if problem remains.

So I just swapped the high and low fan relays to the horn spot and both of them made horn work. So fan issue prob not a relay issue. I am going to put the alternator in tuesday and see if that stops anything. Not sure if maybe the water pump or pump bearing?

I just switched the high with the low and vice versa. So I do not know which one is bad. I think I mis understood you on that for testing it. When the fan was not being loud after I switched them, I heard noise from accessories, put long screw drive to alternator and sounds like that bearing is...

Good day, Is this possible on a 2007 mustang gt? Getting a-lot of noise from alternator. One of my fan relays went bad. Not sure if related. Do I have to buy the whole alternator or can I seap out the bearing? Thank you!!!

Relay swap seemed to respond. Thank you!

It does it without the AC on. And with it on. Where are the relays located that you speak of?

Good day all! Wondering if anyone can please help me out. 2007 mustang gt upon start has the radiator fan sound like a jet engine. It is very loud. Any ideas? Just started yesterday.

Any recommendations besides fluid film to prevent salt from eating underneath? Thank you!

Good Day! Any opinions on rust proofing a 2007 mustang for the winter? Besides getting a beater. I requested a quote to have the underside coated with por-15. Is this worth the money? Generally, I use fluid film on previous vehicles. But have not kept one to see the results. Input welcome...

Hello all! I was doing some reading on 4:10 swap. One thread mentioned I might be able to swap out the housing instead of having a shop install gears in current rear end. I would have shop install this https://lmr.com/item/LRS-4209FRC-K/Mustang-88-410-Ratio-Rear-End-Gear-Kit or would I be...

Thank you for the heads up on this!

Good day all, Going to order BMR UCA, mount and LCA in links below. Question is what additional poly bushings will I need to complete this job? Looks like the UCA comes with one side with bushings. The mount with a bolt. Does anyone have a link for a poly bushing that connects to rear end? I...

They were made by TRQ. Put them in last weekend

I did the rear shocks first and immediately noticed the car got up and moved forward, big improvement of acceleration. I think I am going to go with the bmr non-adj UCA, new mount and LCA. See how that feels. Had them on my old 2006 and felt an improvement then. People have mixed opinions on the...

I replaced all the struts and shocks with stock height parts. I was thinking either rear LCAs, UCA and rear sway bar or spring for the watts bar. The videos make the UCA look not too bad, but I heard read differently. Down the road when I get use out of the current suspension I will look into...