Recent content by cavero

Ok I think I got it now, this'd be so much easier if I could crawl under a car and look. Found some pics on eBay that show how it attaches. #3 on the diagram (vertical bolt) definitely went for scrap with my transmission, along with the square block it threads into. My shifter still has the...

Yeah looks like #3 is what I've got in the picture w/ the plastic bushings. I don't think I have #4 though -edit- but why does the parts diagram make #3 look vertical...

Yeah if you can circle on that diagram what pin and bolts you're talking about, that might help. The only hardware I have is what's in the picture though. If you can find the thread size/pitch on the nuts, you can probably find what you need at the auto parts or hardware store too.

This is what I've got, I'm afraid the other hardware might have gone the way of the stock transmission

I can dig in the garage and see if I still have mine, not sure if I have the bolts, but rocknrod posted the part numbers

Just dropped off the stock intake manifold this afternoon, talked to the owner. > Positives: >> engine is still on track to be done Friday, if so they'll pick it up Saturday >> They'll start installing early next week, should take the mechanic (or wizard as far as I'm concerned) 3 days to put...

Well aint it fun.... Was stopping by the shop this afternoon and noticed a small tear in the car cover. Out of OCD, I went ahead and checked under the cover, maybe...it's fine....ok ok .... just in case.... GODDAAAAAMNIT. I went in and told them about it, they came out looked at with...

Maybe progress is going faster than we both thought. The owner of the performance shop sent me an email, he was visiting the machine shop and my engine's being assembled now (short block machined and fully assembled, rest of assembly continues this week). Machine shop said it could be ready...

Progress is slow, but progress is progressing. They said my engine's next into the assembly room

Did you check the cooling fan resistor?

My upper strut mount nuts loosened on my Steeda upper strut mounts a couple weeks after I installed them, made a loud clunking noise whenever I went over bumps. Did you check the torque on everything like 86GT351 said? Did you get in touch with Steeda? They've got good tech support, helped...

I went through browsing by category, it was under fuel system

This looks like it?

Yeah the interesting thing is the 127400's are supposed to give you more midrange, but the FRPP intake shifts everything to higher RPMs, so it becomes a pretty linear power curve. I overlaid it with my first dyno run (just the CAI and tune), and in the low/mid there were almost no gains, it was...

I know polished tips were a dealer option, wonder if you could source some