Is there a special tool needed to install the rear main seal? The reason I ask is because unlike other engines I’ve worked on there didn’t seem to be a spot where the seal would drive into and seat. I replaced the seal guessed on the depth, used a small socket to make sure it was the same depth all the way around and 6,000 miles later I have a leak. I just put a new clutch in and I really don’t want to soak it in oil, I also don’t want to be pulling the transmission out over and over again on my back. Any help would be helpful. I’m assuming there is some special tool that is needed to get the correct depth. I am debating on taking it to a shop but since I have a supercharger and aftermarket clutch I’m not sure they will want to put the clutch back. I also live in California so I will probably be charged double what the rest of you get charged. Any input would be helpful. I got the seal from NAPA and assumed it’s a quality seal. Most likely it wasn’t installed correctly, I’m assuming you need some sort of special tool that I don’t have or know where to get.