2010 S197
I was doing some voltage tests on a friends S197 while installing a sequencer in the rear RH turn signal, and I managed to short the turn signal power to ground, the clicking stopped as I did this. Now all turn signals and hazards don't work.
Don't ask how...Very embarrassing as I've been working electronics most of my life!
I've checked the S6 fuse in the SJB is good and everything else works fine.
My questions:
With the short circuit removed would a DTC code have latched preventing further operation, requiring a reset?
Why didn't the fuse (6) blow?
How can I perform a reset?
Any other thoughts?
Thanks in advance!
I was doing some voltage tests on a friends S197 while installing a sequencer in the rear RH turn signal, and I managed to short the turn signal power to ground, the clicking stopped as I did this. Now all turn signals and hazards don't work.
Don't ask how...Very embarrassing as I've been working electronics most of my life!
I've checked the S6 fuse in the SJB is good and everything else works fine.
My questions:
With the short circuit removed would a DTC code have latched preventing further operation, requiring a reset?
Why didn't the fuse (6) blow?
How can I perform a reset?
Any other thoughts?
Thanks in advance!