Ya I was talking to Eric Brooks. I am not getting a tune until I get my 60#'s in unless I absolutely have to. So I want to put my motor in and idle my car home. I need to get it out of the shop it is in sooner than later.
07 Aluminator build
- Thread starter explict
- Start date
Ya I was talking to Eric Brooks. I am not getting a tune until I get my 60#'s in unless I absolutely have to. So I want to put my motor in and idle my car home. I need to get it out of the shop it is in sooner than later.
alexthejew
Jewish and lovin it.
certain companies will tweak the tune they send you at no cost, so if you call someone who sells "mail order tunes" they might agree to send you one now and a tweaked one after the 60#s come in, if you just purchase the one now to get your car home.
Haha good thing nobody can see that!
Wait till you see your valve covers....
First day off yesterday, did some work to it. I towed the car down to the shop the motor was in. Removed and replaced the K-member with a BMR one. http://www.s197forum.com/forum/showthread.php?p=450153#post450153
Removed the Spydershaft but never got the new Coast DS in yet. Only actually worked a few hours at it though.
Removed the Spydershaft but never got the new Coast DS in yet. Only actually worked a few hours at it though.
GrnBullitt08
Dale Jr
K member looks good. I need to invest in some weight cutting parts myself.
Camera really makes everything look dirty. Will do a spit-shine when car is done.
Motor is in. Motor mounts on, tranny CM on. Tomorrow is hook everything up day. And start up day as well!
GrnBullitt08
Dale Jr
I like your notes everywhere. Not a bad idea.
NastyStang113
Made in U.S.A.
Are you sure it's the camera making it look dirty...? I think it looks dirty because everything is covered in dirt.
BlownAway05
still too slow
Vapour Trails
The Renaissance Man
Holy christ that is a dirty engine bay. It will be far easier to clean now that you have room.
No room now. And like I said the camera flash makes it look FAR worse than it is.
BlownAway05
still too slow
Same reason why it's better to pick up chicks at the bar
, LOLStill starting up today?
Hopefully. Still got 5 1/2 hours left of work! Not much left to do.
I am just hoping the whipple tune lets it run...
I am just hoping the whipple tune lets it run...
BlownAway05
still too slow
Someone from another forum contacted FRPP and asked that and FRPP said that it should be fine. They aren't as far along as you with the build, so no real world data yet.
Does anyone know if the BMR K-Member moves the engine back at all?
I am having avery hard time getting the steering shaft installed....
I am having avery hard time getting the steering shaft installed....
I think the headers are moved back or something....
The engine is in the original position, unless you bought the K-member that lowers the engine, an inch or so IIRC.
It could be too far over to the left though.
It could be too far over to the left though.
Similar threads
Support us!
Support Us - Become A Supporting Member Today!
Click Here For Details
Sponsor Links
